Western Trap Machine Forum
Trap Information Hosted by Western Retro

Home » Public Forums » Trap Machine Bulletin Board » X 1524 location in trap house
X 1524 location in trap house [message #50] Wed, 16 April 2014 08:59 Go to next message
linus
Messages: 3
Registered: April 2014
Location: michigan
Junior Member
Is there a installation dimension for a X1524 in the trap house(think of the Remington 4100 off set to one side measurement)?..I haven't been able to find anything in the original manuals..Thanks
Re: X 1524 location in trap house [message #51 is a reply to message #50] Wed, 16 April 2014 12:38 Go to previous messageGo to next message
Western Retro is currently offline  Western Retro
Messages: 43
Registered: April 2013
Member
Administrator
index.php?t=getfile&id=59&private=0

I believe this is what you are after. This is diagram was taken from Plate E Trap House and Wiring Diagrams for Westerns.
Trap is offset 12" from the center of the trap house. It also sits 12 inches below grade.

Ian Brotherston Western Retro

[Updated on: Wed, 16 April 2014 12:47]

Report message to a moderator

Re: X 1524 location in trap house [message #53 is a reply to message #51] Wed, 16 April 2014 12:54 Go to previous messageGo to next message
Western Retro is currently offline  Western Retro
Messages: 43
Registered: April 2013
Member
Administrator
Here are two more diagrams for Non Pitted Trap House or Pitted Trap House.
Re: X 1524 location in trap house [message #54 is a reply to message #53] Wed, 16 April 2014 13:06 Go to previous message
linus
Messages: 3
Registered: April 2014
Location: michigan
Junior Member
Thank you very much,that is exactly what I was looking for..
Previous Topic: Troubleshooting a X Model Western Handset
Next Topic: Western Retro eNews - April edition
Goto Forum:
  


Current Time: Thu Aug 16 16:26:29 PDT 2018